Description
8LSA35.E2060D000-0 B&R Automation Servo Motor
8LSA35.E2060D000-0 B&R Automation Servo Motor
8LSA35.E2060D000-0 Embedded parameter chip
All relevant mechanical and electrical information and data is stored in the EnDat encoder used for B&R three-phase synchronous motors. This means that the user doesn’t have to configure settings on the servo drive. As soon as the encoder is connected to the servo drive and power is applied to the electronics, the motor is automatically identified. The motor sends its nominal parameters and limit parameters to the servo drive. The drive then automatically determines the current limits and current control parameters required for optimal control of the motor. The only things that the user has to optimize are the speed and position controllers. The integrated commissioning environment in B&R Automation StudioTM provides all necessary support. In addition to assistance during commissioning, routine service work is also simplified, and motors can be exchanged without having to take extra time to set parameters.
8LSA35.E2060D000-0 Future-proof connections
The uniform connection technology, the pre-assembled cables and the embedded parameter chip allow “plug and play” operation of the power transmission system. The angled connectors can be swiveled for maximum cabling flexibility. Thanks to the digital signal transmission, B&R’s innovative and sturdy single-cable solution (hybrid motor cables) can be used, which combines servo feedback and power for streamlined installation. The winding insulation of motors with an attachment cable and servo drive from B&R are tested extensively in accordance with IEC TS 60034-25 limit curves and are certified by the TÜV in the area of safety technology. In the case of motors with a hybrid connector, the temperature signal is not transmitted via two separate lines as before. Instead, it is transmitted digitally via the encoder interface. The following conditions must be met by the drives in order to operate a motor with a hybrid connector:
■ For ACOPOSmulti: the cable cover must be designed for operation with a hybrid cable (with cable cutout; delivered 2015 or later)
■ For ACOPOSmulti with SafeMOTION: the operating system (NC version) must be set to Version 2.48.0 or higher; the Safety Release must be Version 1.9 or higher
■ For all drives: the operating system (NC version) must be set to Version 2.42.2 or higher
8LSA35.E2060D000-0 NOTE: If the conditions listed above are not met, temperature evaluation on the drive will not work.
E-mail:geabbdcs@gmail.com
WhatsApp:+86 15359293870
Wechat:+86 18106937731
Phone:+86 18106937731
Twitter:@Bella_abbdcs
Telegram:+86 18106937731
Skype:live:.cid.4563d9d89ae553bce